The checklist is a special set of states match conditions that results in a list of check boxes for your operator to see if everything is in the correct place before the beginning of the show.
You can use both inputs and outputs to make your checks. If the set conditions are not met, then the tick box shows as RED. If they values match it shows as GREEN.
E.g. I would like all the doors to be closed before I start the show. I add a check which looks at ALL the door reed switches being OFF - if they are all OFF, the doors are all closed, and the show is ready to start.
You can also use the **States Match: All/ Any** condition to see if a check on the checklist should return RED or GREEN if either All of the states match, or if Any of the conditions match.
E.g. This check would return GREEN when ANY of the Door reed switches are ON as I’m utilising the ANY check.